I seem to remember some suggestions in the media releases for the 5 series that they had done some tweaks for more reliable reading. I did note that Jean said he had successfully identified one as a LokSound 5. I have had trouble with newer Loksound decoders and newer Digitrax hardware in Page mode. I would also say that the user needs to ensure that the decoder is being read in Direct mode and not Page mode. Shouldn't manually entering the address as I did overcome the problem with the address being read incorrectly? Jean But it once again came up with the wrong address, not the address I thought I had just successfully programmed in. I manually selected the LokSound Select decoder type and again tried to read the address. I once again went through the "new loco" process, because I did not want the software to simply display what I had just entered, but rather to actually read it from the decoder. I then decided to see if I could read the address back using DecoderPro. I then exited programming mode and acquired the loco on the throttle and found that it responded as expected to the known decoder address. So I did that, and wrote the results back into the decoder. A "read" from the programming track using DecoderPro of the decoder type does not show ESU as the manufacturer, but rather "Train Tech," mfg id 2 I read somewhere on the web that because of the design of LokSound decoders this is a problem that can occur, and the user should simply override what is shown by the read process and manually enter the decoder address when using DecoderPro. The information on the decoder type in the locos was supplied by Bowser when I asked them about it by email. I have some Bowser locos that have LokSound Select decoders factory installed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |